I'm Looking for some explaination of the 20 Pin I/O cable that comes from controller to the drives.
If you could assist me with better explainations of what these comm signal are that would be great. I assume that the CLK, SER, and strobe signals in pins 1-6 are from the encoder to control positioning. Is the alarm reset a high or low signal.
Also if yuo could explain
Current off & Com
SAOP1-N & com
alarm 1 is it a high or low signal
RXD1 & RXD1-N ??
RXSTB1 & RXSTB1-N ??
Are most of the signal in and out 5Volt or 24 Volt