Can you please help me I have two of your drives (B17 C200 8/16 & 14/28) the 8/16 is my Y axis and the 14/28 is my X axis the CNC that is controlling them is Camsoft with a galil PC control card. How they are controlled is in Velocity Mode +/- 10v into the +Ref and with a jumper from the –Ref to GND on the Drive. The problem I am having is to get the two axes to do small round circles they are oval I am using a feed rate between 400 and 800 m/m per min. (a higher feed rate is needed).
I do have your manual I do know about the trimmer Adjustments (KV; DER; ACC; VEL; BIL) I have followed the book to get the drive’s back to factory settings as best as I can with No good result, can you please tell me which of the above would I have to a just to get the circles round and what else would I need to look for output volts input volts ext.
Please and thank you in advanced
Kind regards
Des Whitaker