On my travel read out on table movement, I have a spot that the Wizard does not pick up. This will allow my tooling to cut deeper into my product than needs to be. Is the pickup on the table adjustable or am I going to have to replace those? I moved my vise back to avoid this problemfor a while but now I have a job that requires me to use that bad area in my readout. Just so you understand what I'm saying, the table will be moving but the Wizard will not reflect that in one small area about .130 of and inch. So if I'm cutting into a part and I need 1.000 deep and Im in that area of my travel, I will get a 1.130 deep cut even though my readout on the Wizard will have 1.000 on it.